咨询热线
当前位置: 首页 > 新闻媒体 > 行业新闻 >

济南车库门常见的问题维修要注意什么?

发布人:http://www.kdjlm.com    发布时间:2018-08-24 17:35:16

1、检查四库内部的金属的轨道,查看将轨道固定到墙壁的安装的支架,如果支架松动了,请您拧紧螺栓或者是螺钉呢。将车库关上以后,库内部的检查轨道是否有凹陷的现像呢、还有就是弯曲的地方呢。如果有任何的损坏之处,请您用橡皮锤,或者是用一块废木料垫着锤子敲打这些地方哟。如果轨道严重损坏的呢,您就必须的更换了。

1. Check the metal track inside the four depots and check the mounting bracket that holds the track to the wall. If the bracket is loose, please tighten the bolts or screws. After closing the garage, check the interior of the garage to see if there is any depression in the track, and there is a bending place. If there are any damages, please hit them with a rubber hammer or a hammer padded with a piece of waste wood. If the track is seriously damaged, you will have to replace it.

2、用水平仪检查轨道,确保了轨道在同一水平线上,水平的轨道应当略向车后部倾斜的哟,如果是卷帘门,轨疲乏的纵向的部分应当精确的垂直。在车库的墙壁上,两条轨道必须处一同一的高度。如果轨道没有准确的对齐呢,请将固定安装的支架的螺钉或螺栓拧松,但不要把它们取下来呀,然后小心地敲打轨道,使它们移动到适当的位置。用水平仪重新的检查轨道,确保它们处于正解的位置,然后将安装的支架上的螺钉或者是螺栓拧紧就可以了。

2. Check the track

20161219618477.jpg with a leveler to ensure that the track is on the same horizontal line and the horizontal track should tilt slightly toward the rear of the car. If the shutter door is rolled, the longitudinal part of the rail fatigue should be precisely perpendicular. On the wall of the garage, the two tracks must be at one height. If the tracks are not aligned properly, loosen the screws or bolts of the mounted brackets, but do not remove them, and then carefully tap the tracks to move them to the proper position. Check the tracks again with the level to make sure they are in the forward position and then tighten the screws or bolts on the mounted brackets.

3、用高浓度的家用清洁剂清洗轨道,去除污垢和硬化的油脂。将转轴乇底的清洗干净,然后将轨道和转轴擦干就好。

3, use high concentration household cleaners to clean the track, remove dirt and hardened grease. Clean the torn bottom of the rotating shaft, then dry the track and the shaft.

4、将石墨粉撒在轨道上,将家用的润滑油或者是硅树脂喷在转轴上,或者是在轨道和转轴上喷洒四库门专用的润滑油喷雾剂就好,以起到了润滑的作用哟。如果有滑轮,请您使用和用在转轴上的相同的润滑剂润滑哟。

4. Sprinkle the graphite powder on the track, spray the household lubricating oil or silicone resin on the shaft, or spray the special lubricating oil spray on the track and the shaft, to play a lubricating role. If there are pulleys, please lubricate it with the same lubricant on the shaft.

有了济南车库门上面的小总结,希望对广大客户有所帮助,如果有什么不理解的或者寻求帮助的请点击我们的官方网站:http://www.kdjlm.com或者来电咨询,我们会尽全力为您解决

With the summary above the garage door in Jinan, I hope it will be helpful to our customers. If you don't understand or ask for help, please click on our official website: http://www.kdjlm.com or call for advice. We will try our best to solve it for you.


上一篇:“车库门”驱动设备的特殊要求
下一篇:车库门及工业大门门板和插销的操作事项
产品中心
联系我们

【本站图片均由网站所有方提供,部分图 片来源于网络,如有任何疑问请第一时间与我们联系,未经沟通本站不承担相关法律责任!】