咨询热线
当前位置: 首页 > 新闻媒体 > 公司动态 >

电动卷帘门安装方法注意要点

发布人:http://www.kdjlm.com    发布时间:2017-01-06 13:25:41

  在安装电动卷帘门需要注意的事项,你知道吗?如下为您介绍一下在安装电动卷帘门的时候需注意的几个要点:

  In the installation of electric shutter doors need to pay attention to matters, you know? Here are some of the key points you should pay attention to when installing the electric rolling shutter door:

  1、复核洞口与产品尺寸是否相符,防火卷帘门的洞口尺寸,可根据3M。

  1, check the hole and the product size is consistent with the size of the fire door, according to 3M.

  2、确定安装水平线及垂直线,按设定尺寸依次安装。槽口尺寸应准确,上 下保持一致,对应槽口应在同一平面内,然后用连接件与洞口内的预埋件焊牢。

  2, determine the installation of horizontal and vertical lines, according to the size of the installation. The slot size should be accurate, consistent, corresponding grooves shall be in the same plane, and then use the connecting piece and the hole in the welding parts.

  3、卷门机必须按说明书要求安装。

  3, rolling door machine must be installed according to the specification requirements.

  4、卷轴、文架板必须牢固地装在混凝土结构上或预埋件上。

  4, the scroll, frame plate must be firmly installed in the concrete structure or embedded parts.

  5、宽大门体需在中间位置加装中柱,两边有滑道。中柱安装必须与地面垂 直,安装牢固,但要拆装方便。

  5, a door body in the middle position is in the column, slide on both sides. The column installation must be perpendicular to the ground, the installation is firm, but to facilitate disassembly.

  6、门体叶片插入滑道不得少于30 mm,门体宽度偏差为土3 mm。

  6, the door leaf is inserted into the slideway of not less than 30 mm, the door body width deviation of soil is 3 mm.

  7、防火卷帘门水幕系统装在防护理下面,喷嘴倾斜15°角。

  7, fire shutter door curtain system installed in the prevention of nursing tilt angle of 15 degrees below the nozzle.

  8、安装完略,先手动调'自试运行,观察门体上下运行情况,正常后通电调试。

  8, the installation is slightly, the first manual adjustment 'self test run, observe the door body running up and down, after the normal commissioning.

  9、观察卷帘机、传动系统、门体运行情况应启闭正常、顺畅,速度为3-7 米/分钟。

  9, to observe the rolling machine, transmission system, the door body should open and close the normal, smooth, speed of 3-7 M / min.

  10、调整制动器外壳方向,使环形链朝下;调整链条张紧度,链条6-10 mm;调整单向调节器及限位器。

  10, adjust the direction of the brake shell, so that the chain down; adjust the chain tension, the chain 6-10 mm; adjust the one-way regulator and limit.

  11、卷筒安装应先找好尺寸,并使卷简轴保持水平位置。注意与导轨之间的距离应两端保将一致,临时固定后进行检查,并进行必要的调篷、校正,无误后再与支架预埋件用电焊焊接。

  11, reel installation should first find good size, and make the roll shaft to maintain a horizontal position. The distance between attention and guide should be guaranteed both ends will be consistent, temporary fixation after the inspection, and make necessary corrections, awning, correct with embedded parts by welding welding bracket.

  12、清理、粉刷或镶砌导轨墙体装饰面层,清理现场。

  如有需要,欢迎新老客户前来选购!我们本着质优价廉的宗旨来为您提供产品和服务。真诚期待与您合作!

  12, cleaning, painting or inlay guide wall decorative surface, clean up the scene.

  If necessary, welcome new and old customers come to buy! We aim to provide you with quality and cheap products and services. Sincerely look forward to working with you!


上一篇:哪种材质的车库门更具防盗性能
下一篇:济南快速卷帘门的特点
产品中心
联系我们

【本站图片均由网站所有方提供,部分图 片来源于网络,如有任何疑问请第一时间与我们联系,未经沟通本站不承担相关法律责任!】