发布人：http://www.kdjlm.com 发布时间：2018-09-13 17:21:05
1, check whether the hole is in conformity with the product size, and the size of the opening of the fire shutter door can be calculated according to 3M.
2. Determine the installation horizontal and vertical lines, and install them in turn according to the set dimensions. The groove size should be accurate and consistent, and the corresponding groove should be in the same plane, and then welded firmly with the embedded parts in the hole.
3, rolling door machine must be installed according to the instructions.
4, reel and rack plate must be firmly installed on concrete structure or embedded parts.
5. Wide gate body should be installed in the middle of the column, both sides of the slide. The installation of the column must be vertical to the ground, installation firm, but to disassemble and install conveniently.
6, door body blade insert slideway must be less than 30mm, door width deviation is soil 3mm.
7, fire shutter door water curtain system installed under the prevention of care, nozzle tilt 15 degrees angle.
8. Installation is short, first manually adjust the'self-test operation, observe the operation of the door body up and down, after normal power-on debugging.
9. Observing the operation of rolling shutter, transmission system and door body should be opened and closed normally and smoothly with a speed of 3-7 m/min.
10. Adjust the direction of the brake housing to make the ring chain face down; adjust the chain tension, chain 6-10mm; adjust the unidirectional regulator and limiter.
11, reel installation should first find a good size and keep the reel shaft horizontal. Attention should be paid to the distance between the guide rail and the two ends of the same, temporarily fixed after inspection, and necessary adjustments, corrections, no error and bracket embedded parts after welding.
The highlight of this article comes from: Jinan remote control garage door more details please click our official website: http://www.kdjlm.com Thank you for coming