咨询热线
当前位置: 首页 > 新闻媒体 > 公司动态 >

如何有效增加卷帘门的使用寿命?

发布人:http://www.kdjlm.com    发布时间:2019-11-12 16:46:21

  快速百叶窗结构并不复杂,通常可以看到产品的概况通过肉眼观察,主要观察门的身体是否取消和关闭顺利,如果不使用快速门很长一段时间最好的常规测试中,测试打开和关闭按钮是否正常,电气控制箱指示信号的情况。更详细的保养可分为变频器的保养、电机的保养、定期检查变频器进口是否有异物堵塞、每月清洗过滤器冷却风道灰尘。年度检查:导体和绝缘体没有腐蚀,如有,应及时用酒精擦拭。

  The structure of the quick shutter is not complicated. Generally, you can see the general situation of the product through visual observation, mainly to observe whether the door body is cancelled and closed smoothly. If you do not use the quick door for a long time, in the best routine test, test whether the open and close buttons are normal, and the indication signals of the electrical control box. More detailed maintenance can be divided into converter maintenance, motor maintenance, regular inspection of converter inlet whether there is blockage of foreign matters, monthly cleaning of filter cooling air duct dust. Annual inspection: conductor and insulator are not corroded, if any, they should be wiped with alcohol in time.

  看看螺栓、螺钉和插件是否松动,有没有对地短路和相阻的输出和输入电抗器,正常情况下应大于几十兆欧。工业和石油污染门上很难清洁,可以用清洁剂擦洗,最好不要使用强酸或碱清洗解决方案,这样不仅容易使表面光洁度受损,还可以破坏保护膜表面的金属碎片和氧化层,导致金属件的腐蚀,尤其是当一些客户的硫酸与墙面清洁,必须注意不要让门窗口的影响。工业门电机可以在适当的时候,做一次保养。

  Check whether the bolts, screws and plug-ins are loose, and whether there is output and input reactor with short circuit to ground and phase resistance, which should be greater than tens of megaohms under normal conditions. It is very difficult to clean industrial and oil polluted doors. You can scrub them with detergent. It is better not to use strong acid or alkali cleaning solutions. This will not only damage the surface finish, but also damage the metal chips and oxide layer on the surface of the protective film, resulting in the corrosion of metal parts. Especially when some customers clean the sulfuric acid and the wall, you must pay attention not to let the impact of doors and windows. The industrial door motor can be maintained at a proper time.

20161214578645.gif

  减速机至少每半年要加润滑油,其他部件也要定期检查,及时更换。在使用过程中,应尽量避免碰撞。对于工业门的扭力弹簧,使用一段时间后,如出现松动情况应及时调整紧,需要立即更换。打开工业门时,强度要适中,还要尽量保持打开和关闭时的速度。防火卷帘门旁边安装控制按钮,当发生火灾时,按下按钮将快门按下。

  The reducer shall be lubricated at least every half a year, and other parts shall be inspected regularly and replaced in time. Collision shall be avoided as much as possible during use. For the torsion spring of industrial door, if it is loose after using for a period of time, it should be adjusted and tightened in time, and it needs to be replaced immediately. When opening the industrial door, the strength shall be moderate, and the speed of opening and closing shall be kept as far as possible. A control button is installed beside the fire shutter door. In case of fire, press the button to press the shutter.

  其次是火灾报警系统的火灾联动控制,火灾报警联动控制系统与防火卷帘门控制器连接时,安装防火卷帘门,火灾报警联动控制系统将信号反馈到防火卷帘门相应部位的电气控制箱中,带动卷帘门下降。这种控制方式是必须实现的控制方式,也是火灾验收的标准。最后,机械控制功能位于疏散走廊两侧的防火卷帘门应设置两侧的百叶窗启闭装置,也要求有机械控制功能,所以防火卷帘门应设置温度保险丝控制装置。

  The second is the fire linkage control of the fire alarm system. When the fire alarm linkage control system is connected with the fire shutter door controller, the fire shutter door is installed. The fire alarm linkage control system feeds back the signal to the electrical control box of the corresponding part of the fire shutter door to drive the shutter door down. This control mode is the control mode that must be realized, and it is also the standard of fire acceptance. Finally, the mechanical control function located on both sides of the evacuation corridor shall be equipped with shutter opening and closing devices on both sides, and also with mechanical control function, so the fire shutter door shall be equipped with temperature fuse control device.


上一篇:卷帘门电机控制器功率远大于电机功率!
下一篇:上滑式车库门的组成优势!
产品中心
联系我们

【本站图片均由网站所有方提供,部分图 片来源于网络,如有任何疑问请第一时间与我们联系,未经沟通本站不承担相关法律责任!】