咨询热线
当前位置: 首页 > 新闻中心 > 公司动态 >

卷帘门按用途主要分为哪几类?

发布人:http://www.kdjlm.com    发布时间:2020-01-16 15:22:38

  按其主要用途,可分为以下几类:

  According to its main use, it can be divided into the following categories:

  通用卷帘门,全透明紫水晶卷帘门,防风卷帘门,防火安全卷帘门,快速卷帘门,电动美式卷帘门,车库卷帘门!

  Universal roller shutter, all transparent Amethyst roller shutter, windproof roller shutter, fire safety roller shutter, fast roller shutter, electric American roller shutter, garage roller shutter!

  卷帘门帘板的工程验收相关标准如下:

  The relevant standards for the engineering acceptance of the roller shutter are as follows:

  1. 卷门窗帘板相邻的自锁互锁连环价值循环旋转方便,摇晃±900跌倒情况是不允许的,以及烟气控制的特点和排气系统后帘板连接的巧合,摇晃±900也不允许倒了。

  1. The value cycle of the adjacent self-locking interlocking link of the rolling door curtain board is convenient to rotate, and the shaking ± 900 falling situation is not allowed, as well as the coincidence between the characteristics of smoke control and the connection of the rear curtain board of the exhaust system, and the shaking ± 900 is not allowed to fall.

  2. 卷闸门帘板工程验收时,帘板应垂直,每米平行度不大于1.5mm,现场整体平行度不大于0.12%。

  2. During the acceptance of rolling gate curtain plate project, the curtain plate shall be vertical, and the parallelism per meter shall not be greater than 1.5mm, and the overall parallelism on site shall not be greater than 0.12%.

  3 .帘板两边的隔断或正反窜组织流水线要牢固,流水线生产后的窗帘,帘板窜角动量不超过2mm。

  3. The partition on both sides of the curtain board or the organization line of forward and reverse movement shall be firm. The angle momentum of curtain board movement after the production line shall not exceed 2mm.

  4. 卷帘门帘板经过流水线后不允许有缝隙和裂纹。

  4. No gap or crack is allowed after the rolling curtain plate passes through the assembly line.

20161214807515.jpg

  5. 具有防排烟系统特点的幕板,内外鼻钩接触后表面应弯曲,接触弧度应在300以内。

  5. For the curtain plate with the characteristics of smoke control and exhaust system, the surface shall be bent after the internal and external nose hooks contact, and the contact arc shall be within 300.

  6 .在门帘板装配线后,在整个操作过程中不允许有歪斜的存在,而应是平行升降,门帘的长度不大于孔宽比的1/300。

  6. After the door curtain panel assembly line, there shall be no skew in the whole operation process, but parallel lifting. The length of the door curtain shall not be greater than 1 / 300 of the hole width ratio.

  卷帘门在左右开合的时候查询是否有杂乱,非常防火安全卷帘门是与消防设施相连的,往往由于实际操作不当造成卷帘门防火安全损坏,或歪斜。和通用电气式百叶窗还应该需要注意,门帘的打开和关闭其他的应该在现场,以防出现的门帘askewness或跟踪运行应立即终止门帘打开和关闭,这是不容易的发动机和门帘造成更大的伤害。

  When the rolling shutter door is opened and closed on the left and right, check whether there is any disorder. The very fire safety rolling shutter door is connected with the fire-fighting facilities, and the fire safety of the rolling shutter door is often damaged or skewed due to improper operation. And Ge type louvers should also be noted that the opening and closing of the curtain and other curtains should be on site to prevent the occurrence of askewness or tracking operation of the curtain should immediately terminate the opening and closing of the curtain, which is not easy for the engine and the curtain to cause greater damage.


上一篇:常用的工业门维修技巧有什么?
下一篇:卷帘门操作要注意这些问题!
产品中心
联系我们