咨询热线
当前位置: 首页 > 新闻中心 > 公司动态 >

济南卷帘门电机的安装步骤及保养

发布人:http://www.kdjlm.com    发布时间:2021-08-30 16:06:26

电动卷帘门电机是很多自动化家装喜欢的装修方式,在现代家居中一般都喜欢用到,那么电动卷帘门电机是怎么安装的?一起看看本文吧!
Electric roller shutter motor is a favorite decoration method of many automated home decoration. It is generally used in modern home. How is the electric roller shutter motor installed? Let's take a look at this article!
一、先在需要安装的门框框口位置画出线。表明尺寸大小,然后找工作人员设计出合适的电动卷帘门,这里要注意的一点是框内高度比门扇的高度要高一点点。
1、 Draw the outgoing line at the door frame opening to be installed. Indicate the size, and then find the staff to design a suitable electric rolling shutter door. What we should pay attention to here is that the height in the frame is a little higher than that of the door leaf.
二、先把济南电动卷帘门的门框固定,这里要先拆掉门框下部的固定板。(注意:洞口两侧地面要预留凹槽,经校正合格后,固定木楔,门框铁脚与预埋铁板件焊牢。用水泥砂浆或强度不低于10MPa细石混凝土嵌塞牢固即可。)
2、 First fix the door frame of Jinan electric rolling shutter door. Here, first remove the fixing plate at the lower part of the door frame( Note: grooves shall be reserved on the ground on both sides of the hole. After correction, fix the wooden wedge, and weld the iron foot of the door frame with the embedded iron plate. Cement mortar or fine aggregate concrete with strength not less than 10MPa can be used to plug firmly.)
三、安装济南卷帘门主体门扇。一定要保证卷帘门与墙体结成整体,封闭性要做好,再粉刷洞口及墙体。粉刷完毕后,门缝应均匀平整,开启电动卷帘门应该自 由轻便,不得有过紧、过松和反弹现象。
3、 Install the main door leaf of Jinan rolling shutter door. Make sure that the rolling shutter door is integrated with the wall, and the sealing shall be done well, and then paint the hole and wall. After painting, the door seam shall be even and flat, and the opening of the electric rolling shutter door shall be free and light without too tight, too loose and rebound.
接下来为大家介绍一下卷帘门的保养事项
Next, let's introduce the maintenance of rolling shutter door
1、检查济南卷帘门的支位偏差及螺丝松紧情况,检查皮带的松紧情况,检查控制器对电机输出清洁机箱内部的油污、灰尘检查及自动电动门各部件的磨损情况、高速门、开关门宽度、速度、制动等情况检查电压参数是否正常维修、更换损坏的部件,业主还需注重自动门的定期保养与维护,自动门由于受安装质量及使用环境的影响,使用过程中难免会发生问题。
1. Check the support deviation and screw tightness of Jinan roller shutter door, check the tightness of the belt, check the controller to clean the motor output, check the oil and dust inside the chassis, check the wear of various parts of the automatic electric door, high-speed door, opening and closing width, speed, braking, etc., check whether the voltage parameters are normal, repair and replace the damaged parts, The owner also needs to pay attention to the regular maintenance of the automatic door. Due to the influence of installation quality and use environment, problems will inevitably occur in the use process of the automatic door.
2、如果长期缺乏保养,导致电动卷闸门存在的隐患及小故障没有及时处理,马达到一定运行电流后做正向运行,将动力传给同步带,再由同步带将动力传给吊具系统使门扇开启;门扇开启后由控制器作出判断,如需关门,通知马达作反向运动,关闭门扇。这些小故障逐渐变成大故障,可能导致自动电动门的瘫痪。感应探测器探测到有人进入时,将脉冲信号传给主控器,主控器判断后通知马达运行,同时监控马达转数,以便通知马达在一定时候加力和进入慢速运行。
2. In case of long-term lack of maintenance, the hidden dangers and small faults of the electric rolling gate are not handled in time. After the motor reaches a certain operating current, it runs in the forward direction, transmits the power to the synchronous belt, and then the synchronous belt transmits the power to the spreader system to open the door leaf; After the door leaf is opened, the controller makes a judgment. If it is necessary to close the door, inform the motor to move in the opposite direction and close the door leaf. These small faults gradually become major faults, which may lead to the paralysis of the automatic electric door. When the induction detector detects someone entering, it transmits the pulse signal to the main controller. After judgment, the main controller notifies the motor to run, and monitors the number of revolutions of the motor, so as to inform the motor to apply force at a certain time and enter slow operation.
上一篇:济南卷帘门厂产品的电动装置是怎样配置
下一篇:电动卷帘门行业发展方向何如创新?
产品中心
联系我们