咨询热线
当前位置: 首页 > 新闻媒体 > 行业新闻 >

车库门扭簧的安装知识

发布人:http://www.kdjlm.com    发布时间:2016-12-02 10:24:00

车库门在有些地方会用到扭簧,扭簧是进行安装车库门的重要部件。
  The garage door is used in some parts of the torsion spring, torsion spring is an important part of the installation of the garage door.
  车库门扭簧的安装首先将扭簧中心支架、尼龙胶圈、固定法兰、与门体重量相匹配的扭簧、锁紧法兰、绕线轮、轴承支架按顺序,套在镀锌钢管上,并注意各零部件是否安装正确。
  The garage door installation of the first torsion spring torsion spring center bracket, nylon ring, fixed flange, and body weight matched torsion spring, a locking flange, a reel, a bearing bracket in sequence, set in galvanized steel pipe, and pay attention to the parts are installed correctly.
  其次是用方头螺钉将扭簧中心支架固定到洞口上部中间位置的短木板上,并注意避开链盒的安装位置。用螺栓将扭簧中心支架、尼龙胶圈、固定法兰和扭簧连接,再将扭簧和锁紧法兰连接。
  The second is using the square head screws will spring center bracket to the middle position of the upper part of the short board, and pay attention to installation position to avoid chain box. The torsion spring center bracket, nylon ring, fixed flange and a torsion spring connected by bolts, then connect the torsion spring and locking flange.
  然后将轴承支架的下端用大帽螺丝和螺帽与水平轨连接件连接固定,轴承支架的上端用方头螺钉固定到侧木框上即可。
  Then the lower end of the bearing bracket with large cap screw and the nut and the horizontal rail connecting the fixed connecting piece, the upper bearing bracket with lag screws fixed to the side of the wood frame can be.
  车库门的扭簧的安装比较简单,但是需要我们注意的要注意车库门的扭簧左右,安装车库门要根据门板的宽度和高度确定两轨道固定性的位置并用水平管测水平。
  Torsion spring garage door installation is relatively simple, but we need to pay attention to pay attention to the torsion spring garage door, garage door to door installation according to the width and height of the two track of the fixed position and horizontal horizontal tube.

上一篇:第一页
下一篇:关于卷帘门的外观性能及相关的知识
产品中心
联系我们

【本站图片均由网站所有方提供,部分图 片来源于网络,如有任何疑问请第一时间与我们联系,未经沟通本站不承担相关法律责任!】