咨询热线
当前位置: 首页 > 新闻中心 > 行业新闻 >

电动卷帘门安装的注意事项

发布人:http://www.kdjlm.com    发布时间:2017-03-02 14:53:43

对于电动卷帘门,相信大家都不陌生,它被广泛适用于商业门面、车库、商场、医院、等公共场所或住宅,电动卷帘门不仅装饰了人们的门面,而且也为人们的使用提供了便利,那在安装的时候,我们应该注意什么呢?下面由济南电动卷帘门厂家的小编为大家详细介绍一下。
The electric shutter doors, I believe we are not unfamiliar, it is widely used in commercial window, garage, shopping malls, hospitals and other public places and residential, electric shutter doors not only decorate the people's appearance, but also provides convenience for people to use, that at the time of installation, we should pay attention to what the following? By the Ji'nan electric door manufacturers Xiaobian to introduce in detail.
1、卷门机必须按说明书要求安装。
1, rolling door machine must be installed according to the specification requirements.
2、确定安装水平线及垂直线,按设定尺寸依次安装.槽口尺寸应准确,上下保持一致,对应槽口应在同一平面内,然后用连接件与洞口内的预埋件焊牢。
2, install the horizontal line and the vertical line, according to the set sizes are installed. The slot size should be accurate, consistent, corresponding grooves shall be in the same plane, and then use the connecting piece and the hole in the welding parts.
3、宽大门体需在中间位置加装中柱,两边有滑道.中柱安装必须与地面垂 直,安装牢固,但要拆装方便。
3, a door body in the middle position is in the column, a slide on both sides. In column must be installed perpendicular to the ground, firm installation, but easy disassembly.
4、安装完略,先手动调自试运行,观察门体上下运行情况,正常后通电调试。
4, install, starting dynamic adjusting and trial operation, observe the door body under normal operating conditions, after commissioning.

济南电动卷帘门5、卷轴、文架板必须牢固地装在混凝土结构上或预埋件上。
5, the scroll, frame plate must be firmly installed in the concrete structure or embedded parts.
6、调整制动器外壳方向,使环形链朝下;调整链条张紧度,链条6-10 mm;调整单向调节器及限位器。
6, adjust the direction of the brake shell, so that the chain down; adjust the chain tension, the chain 6-10 mm; adjust the one-way regulator and limit.
7、卷筒安装应先找好尺寸,并使卷简轴保持水平位置.注意与导轨之间的距离应两端保将一致,临时固定后进行检查,并进行必要的调篷、校正,无误后再与支架预埋件用电焊焊接。
7, the installation should first find a good size, and the volume or shaft to maintain the horizontal position. The distance between attention and guide should be guaranteed both ends will be consistent, temporary fixation after the inspection, and make necessary corrections, awning, correct with embedded parts by welding welding bracket.
8、清理,粉刷或镶砌导轨墙体装饰面层,清理现场。
8, cleaning, painting or inlay guide wall decorative surface, clean up the scene.

上一篇:高速卷帘门设备的使用说明
下一篇:如何选择车间自动车库门
产品中心
联系我们