发布人：http://www.kdjlm.com 发布时间：2019-07-23 11:22:04
Stainless steel shutter tells about the motor hidden in the coil, through the motor rotating drive shaft rotation, to achieve the rise and fall of roll curtain, curtain wrapped in the drum, collapse when the curtain inside the side of the guide slides down. Through the remote control, the curtain can be raised, stopped and dropped. There is also a manual release system, which can be lifted and lowered by a manual rocker in case of power failure.
The story of Crystal Curtain Door tells us that the curtain door is connected in series by multiple joints, and is started by a motor. The curtain door is rotated up and down in a fixed chute with the scroll above the curtain door as the center.
1. According to the material of rolling curtain door, it can be divided into European rolling curtain door, inorganic cloth, mesh, aluminium alloy rolling curtain door and crystal rolling curtain door.
2. From the type of rolling shutter motor: rolling shutter motor: fire-proof rolling shutter motor, Australian rolling shutter motor, outer rolling shutter motor, tubular rolling shutter motor, inorganic double shutter motor, rolling shutter motor. Different electric curtain doors have their own characteristics, which depends on the needs of customers.
3. The use of rolling curtain doors can be divided into many kinds: according to the different uses of each user, there are silent, noise-reducing, stainless steel rolling curtain doors, air doors, fire-proof rolling curtain doors and crystal rolling curtain doors. Operation method of electric rolling shutter door:
1. 在要安装的门框的开启位置上画一条线。说明尺寸后，再请工作人员设计一款合适的电动卷帘门，这里值得注意的是，框的高度比门的高度略高一些。2. 首先将卷帘门的门框固定好，并将门框下方的固定板取下。(注:孔两侧地面预留沟槽。校准后，固定木楔，将门框铁脚焊接到预埋的铁板上。采用水泥砂浆或强度不小于10MPa的细石混凝土嵌实线。
1. Draw a line on the opening position of the door frame to be installed. After explaining the size, the staff are asked to design a suitable electric rolling shutter door. It is noteworthy that the height of the frame is slightly higher than that of the door. 2. Firstly, fix the door frame of the rolling shutter door, and remove the fixing plate under the door frame. (Note: Grooves are reserved on both sides of the hole. After calibration, the wooden wedge is fixed and the iron foot of the door frame is welded to the embedded iron plate. Use cement mortar or fine stone concrete embedded line with strength not less than 10 MPa.
3. The main fan should be installed in the rolling shutter door. To ensure that the curtain door and wall into a whole, closed, and then the hole and wall paint well. After plastering is finished, the door seam should be even and smooth, and the rolling shutter door should be moved freely without any tightness, looseness and springback.