咨询热线
当前位置: 首页 > 新闻中心 > 行业新闻 >

那电动卷帘门脱钩了怎么办?

发布人:http://www.kdjlm.com    发布时间:2020-01-19 17:58:21

  因为电动卷帘门是由端板、卷筒、卷帘门电机、链条、导轨、卷帘片、控制柜等部件组成。电动卷帘门的推挽式导轨必须完成,如果电动百叶窗经常出轨往往会出现卡,经常出现很容易上周一或以上的状态,可以松电子快门往往会出现自动推拉门,很容易造成他人损害的,那电动卷帘门脱钩了怎么办?

  Because the electric roller shutter is composed of end plate, drum, roller shutter motor, chain, guide rail, roller shutter, control cabinet and other components. The push-pull guide rail of the electric rolling shutter must be completed. If the electric shutter is often derailed, it will often appear stuck, which is easy to last Monday or above. If the electronic shutter can be released, it will often appear automatic sliding door, which is easy to cause damage to others. What about the decoupling of the electric rolling shutter?

  首先了解电动卷帘门解耦所造成的几种情况:

  First, understand several situations caused by decoupling of electric rolling shutter door:

  一、电动卷帘门轴管断裂现象。

  1、 Fracture phenomenon of the axle tube of the electric roller shutter.

  二、电动卷帘门轴管固定座固定螺栓松动,使固定座固定下来。

  2、 The fixing bolts of the fixing base of the electric roller shutter shaft pipe are loose to fix the fixing base down.

  三、将电动卷帘门的轴管与固定座固定通过网线落下,使轴管固定固定分开。

  3、 Fix the axle tube of the electric roller shutter door and the fixed seat by the net wire, so that the axle tube is fixed and separated.

  四、电动百叶窗的叶片脱离,或与轴管固定螺丝松动,使门页脱落。

  4、 The blade of the electric louver is detached, or the fixing screw with the shaft tube is loose, which makes the door leaf fall off.

  五、门板被拉后卡住,刀口脱臼。

  5、 The door is stuck after being pulled, and the knife edge is dislocated.

20161214807515.jpg

  故障检测一定要做检修,电动卷帘门解耦要特别注意解决:

  The fault detection must be overhauled, and the decoupling of electric rolling shutter door shall be solved with special attention:

  1、在重新安装过程中一定要注意线路的完整性,规范使用和安装卷帘门。

  1. In the process of re installation, pay attention to the integrity of the circuit, standardize the use and installation of roller shutter doors.

  2、人们在使用电动卷帘门时要注意电动卷帘门的轨道和悬挂滑轮不能上油,否则滚筒就会在悬挂器上滑动,使门发生碰撞。

  2. When using the electric roller shutter, people should pay attention that the track and suspension pulley of the electric roller shutter should not be oiled, otherwise the roller will slide on the hanger, causing the door to collide.

  3、电动百叶窗脱轨脱钩或因为线,或操作一条线没有连接在一个电路,或一条线坏了在装卸的过程中,优先检查电源电路的情况稍后再检查其他项目,如检查马达线和继电器电源插头下跌是由于振动并导致机械故障。

  3. When the electric louver is derailed or uncoupled, or a line is not connected to a circuit, or a line is broken, during the loading and unloading process, it is preferred to check the condition of the power circuit, and then check other items later, such as checking that the motor line and the relay power plug fall due to vibration and mechanical failure.


上一篇:车库门款式该如何设计好?
下一篇:防火卷帘门的防火性能会受哪些因素影响?
产品中心
联系我们