咨询热线
当前位置: 首页 > 新闻中心 > 行业新闻 >

车库门定期保养需注意6点事项

发布人:http://www.kdjlm.com    发布时间:2021-03-24 17:11:58

1.检查弹簧
1. Check the spring
在上掀门上,每一面的弹簧都挂在槽中。将弹簧钩移至相邻的槽中,调整其弹力。在卷帘门上,每一面的弹簧均由滑轮上的弹簧式缆线控制。为了调整弹簧的弹力,请将经过门上方平板的缆线拉长,然后在末端重新打结,以保持新的弹力。警告:如果卷帘门只在门中央有一个扭转弹簧,请不要尝试修理它。因为那弹簧的弹力实在是太大了,可能会使您受伤。对于使用了这种弹簧的门,应当打电话向专业维修服务部门求助
On the top lift door, the spring on each side is hung in the slot. Move the spring hook to the adjacent slot to adjust its elastic force. On the rolling shutter door, the spring on each side is controlled by the spring cable on the pulley. In order to adjust the spring force, please lengthen the cable passing through the flat plate above the door, and then re knot at the end to maintain the new spring force. Warning: if the shutter door has only one torsion spring in the center of the door, do not try to repair it. Because the spring force is too big, it may hurt you. For doors that use this spring, you should call a professional service department for help
2.将所有变松的螺丝拧紧
2. Tighten all loose screws
请查找变松的部件,并根据需求上紧。在上掀门上,检查安装弹簧的平板,确保螺钉已经旋紧,并将变松的螺钉拧紧。在卷帘门上,请检查将门的各个部分固定在一起的铰链,将所有变松的螺钉拧紧,并更换受损的铰链。门有时向一侧下沉,这个问题往往可以通过维修铰链来纠正。如果螺钉孔变大了,请换一根直径相同但更长的螺钉,在一根空心纤维棒上涂木工胶,然后套在新螺钉上。如果铰链处的木料出现裂缝,请拆掉铰链,将木料填孔剂填在裂缝和螺钉孔中。待填孔剂干燥后再更换铰链。如果可能,请将铰链移到实心木料上。
Please find loose parts and tighten them as required. On the top lift door, check the flat plate with spring, make sure that the screw has been tightened, and tighten the loose screw. On roller shutter doors, check the hinges that hold the various parts of the door together, tighten all loose screws, and replace the damaged hinges. Sometimes the door sinks to one side, which can be corrected by repairing the hinge. If the screw hole becomes larger, replace it with a screw of the same diameter but longer, apply wood glue to a hollow fiber rod, and then put it on the new screw. If there are cracks in the wood at the hinge, remove the hinge and fill the cracks and screw holes with wood filler. Replace the hinge after the filler is dry. If possible, move the hinge onto the solid wood.
3.确保轨道是否在水平线上
3. Make sure the track is on the horizontal line
用水平仪检查轨道,确保轨道在同一水平线上。水平轨道应当略向车库后部倾斜,如果是卷帘门,轨道的纵向部分应精确垂直。在车库的墙壁上,两条轨道必须处于同一高度,如果轨道没有准确对齐,请将固定安装支架的螺钉或螺栓拧松,但不要把它们取下来,然后小心地敲打轨道,使它们移动到适当的位置。用水平仪重新检查轨道,确保它们处于正确的位置,然后将安装支架上的螺钉或螺栓拧紧。
Check the track with a level gauge to ensure that the track is on the same horizontal line. The horizontal track should be slightly inclined to the rear of the garage. In case of rolling shutter, the longitudinal part of the track should be exactly vertical. On the wall of the garage, the two rails must be at the same height. If the rails are not aligned accurately, please loosen the screws or bolts that fix the mounting bracket, but do not take them off, and then knock the rails carefully to make them move to the appropriate position. Recheck the tracks with a level to make sure they are in the correct position, and then tighten the screws or bolts on the mounting bracket.
4.检查金属轨道
4. Check the metal track
检查车库内部的金属轨道,查看将轨道固定到墙壁的安装支架。如果支架松了,请拧紧螺栓或螺钉。将车库门关上,在车库内部检查轨道是否有凹陷、弯曲或变平的地方,如果有任何损坏之处,请用橡皮锤,或用一块废木料垫着锤子敲打这些地方。如果轨道严重损坏,您必须更换。
Check the metal rails inside the garage and see the mounting brackets that secure the rails to the walls. If the bracket is loose, tighten the bolts or screws. Close the garage door and check inside the garage for sunken, bent or flattened tracks. If there is any damage, please use a rubber hammer or a piece of waste wood to hammer these places. If the track is seriously damaged, you must replace it.
5.在轨道上喷洒润滑油
5. Spray lubricating oil on the track
将石墨粉撒在轨道上,将家用润滑油或硅树脂喷在转轴上,或者在轨道和转轴上喷洒车库门专用润滑油喷剂,以起到润滑作用。如果有滑轮,请您使用和用在转轴上的相同的润滑剂润滑。
Sprinkle graphite powder on the track, spray household lubricating oil or silicone resin on the shaft, or spray special lubricating oil spray for garage door on the track and shaft to play a lubricating role. If there is a pulley, please use the same lubricant as used on the shaft.
6.将轨道污垢去除干净
6. Clean the track dirt
用高浓度家用清洁剂清洗轨道,去除污垢和硬化的油脂。将转轴彻底清洗干净,然后将轨道和转轴擦干。
Clean the track with high concentration household cleaner to remove dirt and hardened grease. Clean the shaft thoroughly, and then dry the track and shaft.
上一篇:车库门卷帘、翻板两种类型介绍!
下一篇:卷帘门开门时怎么发生感应的你知道吗?
产品中心
联系我们