咨询热线
当前位置: 首页 > 新闻中心 > 行业新闻 >

济南车库门开门机常见故障处理方法

发布人:http://www.kdjlm.com    发布时间:2021-07-26 15:31:53

随着车辆的增加,人们越来越重视an全,越来越多的地方安装了车库门,但在使用过程中不可避免地会出现一些故障,所以今天我们来看看济南车库门开门机的常见故障解决方案!
With the increase of vehicles, people pay more and more attention to the safety of garage doors. Garage doors are installed in more and more places, but some faults will inevitably occur in the process of use. Therefore, today we take a look at the common fault solutions of Jinan garage door opener!
一、门停止,但不能完全关闭:重复“设置ji限”一节中详细说明的例行程序。门臂长度、关闭力或向下(关闭)ji限调整后,应重复an全反向测试。
1、 The door stops but cannot be fully closed: repeat the routine detailed in the "setting Ji limits" section. After adjusting the arm length, closing force or downward (closing) Ji limit, repeat an full reverse test.
二、开门机可以用门控制面板操作,但不能用遥控器操作:必要时更换电池(一般国产车库门开门机遥控器的电池寿命约为5年)。如果你有两个或更多的遥控器,只有一个可以使用,重复编程开门器和遥控器章节中详细描述的例行程序。门控按钮闪烁吗?此时,开门机上的锁定特性已经启用。如果你有一只多功能门控板,持续按下锁定按钮2秒钟。门控按钮会停止闪烁。
2、 The door opener can be operated by the door control panel, but not by the remote controller: replace the battery if necessary (generally, the battery life of the remote controller of domestic garage door opener is about 5 years). If you have two or more remote controls and only one can be used, repeat the routine described in detail in the door opener and remote control section. Does the door control button flash? At this time, the locking feature on the door opener has been enabled. If you have a multifunction door control panel, press the lock button continuously for 2 seconds. The door control button will stop flashing.
三、门无明显原因即逆向移动且逆向运动后开门机灯闪烁5秒钟:检查保护系统(红外传感器)(如果安装了这个附件)。如果发光二ji管指示灯闪烁,则校正对准。
3、 There is no obvious reason for the door to move in reverse direction and the light of the door opener flashes for 5 seconds after the reverse movement: check the protection system (infrared sensor) (if this accessory is installed). If the LED Ji indicator flashes, correct the alignment.
四、没有明显的原因门作反向运动,而且开门机灯不闪烁:有什么东西挡住门了吗?拉动释放柄。用手操作门。如不平衡或卡住,应找合格人员进行维修。在车库门关闭的地方,从车库地面上清扫冰或雪。重复说明书中设定ji限和设定力章节中详细说明的例行程序。进行任何必要的调整后,均应重复an全反向测试。
4、 There is no obvious reason why the door moves in the opposite direction, and the light of the door opener does not flash: is there anything blocking the door? Pull the release handle. Operate the door by hand. If it is unbalanced or stuck, it shall be repaired by qualified personnel. Remove ice or snow from the garage floor where the garage door is closed. Repeat the routine detailed in the set Ji limit and set force sections of the manual. After making any necessary adjustments, the an full reverse test shall be repeated.
五、济南车库门自行打开和关闭:确保遥控器上的按钮没有卡在“开”位置上。
5、 Jinan garage door opens and closes by itself: make sure the button on the remote control is not stuck in the "on" position.
六、遥控器范围不足:安装电池了吗?改变遥控器在车中的位置。金属车库门,背部有箔的绝缘和金属挡板会缩小传输范围。
6、 Insufficient remote control range: is the battery installed? Change the position of the remote control in the vehicle. Metal garage doors, foil insulation on the back and metal baffles will narrow the transmission range.
七、向下向后拉手柄上的手动释放绳分开滚轮。此时可以用手打开和关闭车库门。恢复供电时,直接向下拉释放柄。下一次启用车库门开门机时,滚轮会自动重新连接。停电情况下,作为附件的外部快速释放装置从车库外面断开滚轮。
7、 Pull the manual release rope on the handle downward and backward to separate the roller. At this time, the garage door can be opened and closed by hand. When the power supply is restored, directly pull down the release handle. The next time the garage door opener is activated, the rollers will automatically reconnect. In case of power failure, the external quick release device as an accessory disconnects the roller from the outside of the garage.
上一篇:什么样的卷帘门厂家才是好厂家?
下一篇:车库门遥控钥匙容易出现哪些问题?
产品中心
联系我们