咨询热线
当前位置: 首页 > 新闻中心 > 行业新闻 >

电动卷帘门边角脱落的原因与解决方法

发布人:http://www.kdjlm.com    发布时间:2021-09-24 13:58:11

使用过电动卷帘门的业主,应该都会有这样的疑问,就是它使用一段时间之后,会出现后门的比较脱落,这是什么原因呢?今天小编就来具体分析一下原因与解决方法。
Owners who have used the electric rolling shutter door should have such a question that the back door will fall off after it is used for a period of time. What is the reason? Today, Xiaobian will specifically analyze the causes and solutions.
1、清洁帘布时,采用软的棉布擦拭,用硬币很容易划伤表面,污迹太重时,可以使用清洗剂、牙膏、专用清洗剂等。去污后用清水擦拭,然后擦干,正确的清洁方法能够使快速电动卷帘门始终保持亮丽如新。
1. When cleaning the cord fabric, wipe it with soft cotton cloth. It is easy to scratch the surface with coins. When the stain is too heavy, you can use cleaning agent, toothpaste, special cleaning agent, etc. After decontamination, wipe it with clean water and then dry it. The correct cleaning method can always keep the fast electric rolling shutter door as bright as new.
2、注意棱角处不要过多的擦磨,否则会造成棱角表皮层脱落。
2. Pay attention not to rub the edges and corners too much, otherwise it will cause the edge epidermis to fall off.
3、使用前应由工作人员有用调试好后,方可对门体进行运行操作。
3. Before use, the door body can be operated only after being debugged by the staff.
4、电动卷帘门体在运行的时候,门体下方禁止有小孩或物品,以免运行过程中伤到小孩或物品。
4. When the electric rolling shutter door body is running, children or articles are prohibited under the door body to avoid hurting children or articles during operation.
5、在运行过程中观察是否有异常响动,如有异常噪音,需通知人士进行维护保养。
5. Observe whether there is abnormal noise during operation. If there is abnormal noise, notify people for maintenance.
6、当电动机的热保护连续发生动作时,应查明故障来自电动机还是超负荷或保护装置整定值太低,消 除故障后,方可投入运行。
6. When the thermal protection of the motor acts continuously, find out whether the fault is from the motor or overload or the setting value of the protection device is too low. After the fault is eliminated, it can be put into operation.
7、应电动机在运行过程中良好的润滑。一般的电动机运行5000小时左右,即应补充或更换润滑脂,运行中发现轴承过热或润滑变质时,液压及时换润滑脂。更换润滑脂时,应清 除旧的润滑油,并有汽油洗净轴承及轴承盖的油槽,然后将ZL-3锂基脂填充轴承内外圈之间的空腔的1/2(对2极)及2/3(对4、6、8极)。
7. The motor shall be well lubricated during operation. Generally, when the motor runs for about 5000 hours, the lubricating grease shall be supplemented or replaced. When the bearing is overheated or the lubrication is deteriorated during operation, the hydraulic pressure shall change the lubricating grease in time. When replacing the grease, remove the old lubricating oil and clean the oil groove of the bearing and bearing cover with gasoline, and then fill 1 / 2 (for 2 poles) and 2 / 3 (for 4, 6 and 8 poles) of the cavity between the inner and outer rings of the bearing with zl-3 lithium grease.
8、因门体始终处于扭簧拉力状态,如需修理维护等工作,需联系人士操作。
8. Since the door body is always in the tension state of torsion spring, if repair and maintenance are required, contact people for operation.
以上就是电动卷帘门边角脱落的原因与解决方法介绍,希望对你有帮助。
The above is the reason and solution of the corner falling off of the electric rolling shutter door. I hope it will be helpful to you.
上一篇:如何选择适合自己需求的车库门?
下一篇:济南电动卷帘门的开关使用规范有哪些?
产品中心
联系我们